Instructions for use:
A. Flash firmware for DOS mode:
* IDE interface Drive: Before Flash Procedure, please make sure the following:
1 Build a boot disk (floppy) on Windows 98.
2 Unzip the firmware to the other one floppy disk.
3 Boot to DOS mode, and change the firmware disc.
4 If connect the drive to Secondary IDE Channel / Master. Please type "A:> FL 3".
5 If connect the drive to Secondary IDE Channel / Slave. Please type "A:> FL 4".
6 When it flashes to 100%, then finish. And restart computer.
* Warning! Flash program can't use on DOS mode of Windows!