Edimax EN-9130A Driver Reviews

User Reviews and Ratings

Only reviews are shown below. Ratings submitted without a review are used in calculating the total ratings shown above, but will be displayed below.

4 of 5 people found the following review helpful:

Guido
Tested on Windows XP

21 May 2008

Installation:

Stability:

Compatibility:

"After initial problems and changing the used slot on the mainboard, this drivers works fine for me."

Was this review helpful?

(Report this)

4 of 5 people found the following review helpful:

Jean-Louis
Tested on Windows XP

17 May 2008

Installation:

Stability:

Compatibility:

"Based on Edimax indications, you install the board as a Realtek.

The driver comes up with a "official windows says": not enough resources.

You check every driver. You make sure that no hidden device bugs and ...

still not works. You take the board, bring it back to the shop (it sells $2 on Ebay!) and never go to an Edimax product again."

Was this review helpful?

(Report this)

Ratings & Reviews may be submitted after downloading and using or attempting to use the driver or firmware.