Magic Control Serial on USB Port Driver Reviews

User Reviews and Ratings

Only reviews are shown below.  Ratings submitted without a review are used in calculating the total ratings shown above, but will be displayed below.

4 of 5 people found the following review helpful:
walkerman8018
Tested on Windows XP
3 Aug 2006
 

Installation: 3 out of 5
Stability: 3 out of 5
Compatibility: 3 out of 5
 
"I first had to consider the age of this device. The 3U1S1P was purchased more than five years ago, it is a 3 hub usb port w/1 - 9 pin and 1 - 25 pin serial port. With this in mind any help was appreciated. The device has always worked even without the updated drivers. The annoying problem is that the found new hardware wizard continues to pop-up although the device works p
spacer
Was this review helpful? Yes, it was helpful No, it was not helpful (Report this)
 
3 of 4 people found the following review helpful:
Roland Hechtenberg
Tested on Windows 7
29 Mar 2010
(11 minutes after download)
 

Installation: 1 out of 5
Stability: 1 out of 5
Compatibility: 1 out of 5
 
"The driver was not accepted by Windows 7"
spacer
Was this review helpful? Yes, it was helpful No, it was not helpful (Report this)
 
3 of 4 people found the following review helpful:
Greg Kirkpatrick
Tested on Windows XP
31 Mar 2006
 

Installation: 5 out of 5
Stability: 5 out of 5
Compatibility: 5 out of 5
 
"Install of the Belkin F5U012 ExpressBus Plus went well with this driver (ibay_w2k1001.zip) in Windows XP Professional with Service Pack 2 and all Microsoft updates as of 2006 Mar 31. One minor snag: the Serial port got a Code 10 (cannot start) error during initial setup, but a reboot fixed that. USB ports installed fine. The Parallel port did not seem to install, however
spacer
Was this review helpful? Yes, it was helpful No, it was not helpful (Report this)
 

Add Your Review

Ratings & Reviews may be submitted after downloading and using or attempting to use the driver or firmware.

This website is not affiliated with Magic Control. All company names/logos are properties of their owners.
server: web3, load: 3.81