Garmin GPS III Pilot Driver Download (Official)

Changes made from version 2.11 to 2.12:

Changed to handle an increased number of intersections.

Changes made from version 2.10 to 2.11:

Added MGRS position format.

Improved messages and terminology relating to DGPS input.

Modified the arrival alarm to give approach notification at intermediate route waypoints when set to "On".

Added capability to change the waypoint auto-naming number. If the user enters a 1, 2, or 3-digit waypoint name, the corresponding number is used for auto-naming.

Adjusted times recorded in track points by applying leap seconds.

Increased maximum backlight brightness.

Adjusted the definition of the Hu-Tzu-Shan map datum.

Corrected handling of long route and track log names in messages when in por

Corrected problem related to revisiting the Routes page after changing the display orientation from portrait to landscape.

System requirements

The following are required to upload the software update into your Garmin GPS unit:

IBM-compatible PC running Windows 98, Windows ME, Windows 2000, Windows NT 4.0, or Windows XP operating system and an available Com 1, 2, 3, or 4 port.

PC Interface Cable for your GPS unit. The PC Interface Cable may be purchased through your local Garmin distributor or ordered direct from our

Instructions for uploading the new software to your unit

Click on "Download" and choose to save the file to your computer.

Choose a location where you can easily locate the file by saving it to a location such as the "My Documents" folder or to "C:\".

Once the download is complete, go to the location where you saved the file.

Locate the downloaded file and double-click on it. This will launch the Win-Zip Self Extractor. This program compresses the data to allow for a faster download of the needed files.

A program window will appear asking you where to "Un-zip" the files. This is by default C:\Garmin. You can change this location if you like. Be sure to note where the un-zipped files are going to allow you to find them!

Click on the button labeled "Un-zip".

Once the un-zip process is complete, click on the "Close" button to exit the Win-Zip Self Extractor.

Open the C:\Garmin (or other folder where you un-zipped the files), locate the file named "Updater" and double click on it.

Connect your GPS to your computer using a Garmin PC Interface cable to an open serial port. Turn the GPS on, place it in Simulator mode (refer to your owner's manual for instructions) and verify that the Interface Mode (found under the Main Menu page, refer to your owner's manual for instructions) is set to Garmin, GRMN, GRMN/GRMN, or Data Transfer/Host mode.

Click on the "OK" button on the Updater program window to start the data transfer.

It is recommended that you disable screen savers or other programs running on your PC while you go through the update process. Disruptions to the update process may render your GPS inoperable. If the transfer is interrupted, turn off the GPS and then turn it back on. Reboot your PC, go to step #8 and attempt the download again. Garmin is not responsible for failed downloads of operating software to the GPS and factory resetting the GPS unit will fall under our Flat Rate Repair Policy.

Driver File